AC Not Cooling? 10 Checks Before You Call a Technician

Quick answer: When an AC runs but does not cool, the cause is usually simple: the remote is on Fan, Dry or Auto instead of Cool, the filters are clogged, the outdoor unit cannot breathe, or the room has more heat than the AC can remove. Check those first. If the air from the indoor unit is still warm after 15 minutes on Cool, the cause may be gas, the compressor or a fault, and a technician should look at it.
Check these 10 things, in this order
- Mode on the remote. It must show Cool (a snowflake). Fan only moves air, Dry mainly removes moisture, and Auto may not cool hard.
- Set temperature. If the set temperature is above the room temperature, the compressor will not start. Set it a few degrees below the room.
- Filters. Open the front panel and look at the mesh filters. ENERGY STAR advises checking filters monthly and warns that a dirty filter raises energy costs and can damage the equipment. Rinse them in plain water and let them dry in shade.
- Outdoor unit air flow. The outdoor unit must push heat out. Remove anything stacked around it, and make sure it is not blowing hot air back into itself from a wall or a box.
- Dirty coils. ENERGY STAR notes that dirty coils reduce the system’s ability to cool and make it run longer. Dust on the outdoor coil is common after a dusty spring; coil cleaning is a service job.
- Too much heat in the room. Doors left open, strong afternoon sun, a kitchen nearby or a crowd of guests can all exceed what the AC can handle. An AC that is too small for the room will run all day and still feel weak; see the right AC size for your room.
- Low voltage or a current limit. When the voltage drops, an AC may run weaker or stop to protect itself, and some models have an ampere lock that caps the current they draw, which also limits cooling. Check the voltage and the AC’s power settings in the manual.
- Ice on the indoor coil or pipes. Ice usually means poor air flow (blocked filters) or low gas. Switch to Fan for a while to melt it, clean the filters, and call service if it returns.
- Water dripping from the indoor unit. ENERGY STAR notes that a plugged condensate drain can cause water damage and affect indoor humidity. A blocked drain pipe is a quick service fix.
- Error code on the display. Write it down and send it to the branch or the brand’s service centre. It saves a visit.

When is it a gas problem?
Many people ask for a gas refill first, but gas does not get used up in a sealed system. If the gas is low, there is a leak, and the leak should be found and fixed before a refill. ENERGY STAR warns that too much or too little refrigerant makes a system less efficient, so a refill must be measured with gauges for the gas on the nameplate. Read R32 vs R410A to know which gas your AC uses.
Quick fixes vs technician jobs
| You can do it | Call a technician |
|---|---|
| Set Cool mode and a lower temperature | Gas leak check and refill |
| Rinse and dry the filters | Coil cleaning (indoor and outdoor) |
| Clear space around the outdoor unit | Blocked drain pipe |
| Close doors and curtains in the afternoon | Error codes and electrical faults |
| Check the voltage and power settings | Compressor or PCB problems (often under warranty) |
Is it covered by warranty?
Compressor and parts faults on a new AC are usually covered by the manufacturer. Our split ACs list warranties such as 10 years on the compressor and 4 to 5 years on the PCB or parts, depending on the brand. Keep your invoice and warranty card, and contact the branch you bought from or the brand’s service centre. Cleaning, gas refills after a leak caused by damage, and installation faults may not be covered.
How to stop it happening again
- Clean the filters every month in summer.
- Have the coils serviced before the hot season starts.
- Keep the outdoor unit in shade with free air flow.
- Set about 26°C, which ENERGY STAR suggests as a comfortable, efficient setting, and use a fan alongside.
Frequently asked questions
Why is my AC running but not cooling?
The most common causes are the wrong mode on the remote, clogged filters, a blocked or dirty outdoor unit, or more heat in the room than the AC can handle. If none of these fixes it, a technician should check the gas and compressor.
Why is my AC fan running but no cool air?
The compressor is probably not running. Check that the mode is Cool, the set temperature is below the room temperature and the voltage is normal. If the outdoor unit is silent, call for service.
Does an AC need a gas refill every year?
No. Gas circulates in a sealed system. If it is low, there is a leak that should be found and repaired before refilling.
Why does my AC not cool in humid weather?
In humid weather the AC spends part of its effort removing moisture, so the room can feel less cool. Keep doors and windows closed and check the filters.
Why is my AC not reaching the set temperature?
The room may have more heat than the AC can remove, from sun, people or open doors, or the AC may be too small. Check the size with our AC size calculator.
Next steps
If your AC is old and keeps failing, compare new DC inverter models in our split AC range and read our split AC buying guide. To estimate running cost, see inverter AC units per hour.
Also read: AC modes explained, does an inverter AC need a stabilizer?.
Sources
- ENERGY STAR, Maintenance Checklist: energystar.gov maintenance checklist
- ENERGY STAR, Room Air Conditioners: energystar.gov/products/room_air_conditioners
